This, however, is no longer the case today.ĪTSC and ClearQAM products ATSC and ClearQAM devices by HauppaugeĪnalog TV is supported, but digital TV is not.Īnalog and digital "hybrid" stick two versions exist - essentially rebrands of the 950 & 950Q modelsĪnalog and digital (ATSC-only) "hybrid" stickĪnalog and digital "hybrid" stick (digital only supported)ĭigital TV is supported, but analog TV is not.ĭigital mode in recent kernels. Postal code: IG10 2BY.Many of Hauppauge's early DVB-S and DVB-T products were actually rebranded TechnoTrend devices. My exact location is Loughton, Essex, UK. I also live (geographically) in a high area. My antenna is attached to the external chimney on top of the property (this is the highest point in the property). Yes, my digital TV is able to pickup all UK Freeview channels without any tell us more about antenna setup please post a photo of this antenna and your exact location where you live at based on this photo it looks like you're get ghosting signal often caused when a TV signal travels by two different paths to a receiving antenna, with a slight difference in timing. So my signal would be PAL and T2.ĭoes your antenna setup and this card work elsewhere? My nearest transmitter is Crystal Palace. em28xx 1-3:1.0: Remote control support is not available for this live in the UK just outside north-east London. em28xx 1-3:1.0: reading from i2c device at 0xa0 failed (error=-5) em28xx: Registered (Em28xx Input Extension) extension em28xx 1-3:1.0: Remote control support is not available for this card. em28xx 1-3:1.0: Input extension successfully initialized rc rc0: lirc_dev: driver em28xx registered at minor = 0, scancode receiver, no transmitter em28xx 1-3:1.0: Registering input extension em28xx: Registered (Em28xx dvb Extension) extension em28xx 1-3:1.0: DVB: registering adapter 1 frontend 0 (Silicon Labs Si2168). em28xx 1-3:1.0: DVB extension successfully initialized em28xx 1-3:1.0: DVB: registering adapter 0 frontend 0 (Silicon Labs Si2168). usbcore: registered new interface driver em28xx em28xx 1-3:1.0: dvb ts2 set to bulk mode. em28xx 1-3:1.0: We currently don't support analog TV or stream capture on dual tuners. tveeprom: has no radio, has IR receiver, has no IR transmitter tveeprom: audio processor is None (idx 0) tveeprom: TV standards PAL(B/G) NTSC(M) PAL(I) SECAM(L/L') PAL(D/D1/K) ATSC/DVB Digital (eeprom 0xfc) tveeprom: tuner model is SiLabs Si2157 (idx 186, type 4) em28xx 1-3:1.0: Identified as Hauppauge WinTV-dualHD DVB (card=99) em28xx 1-3:1.0: microcode start address = 0x0004, boot configuration = 0x01 em28xx 1-3:1.0: DVB interface 0 found: bulk
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |